Geert Uytterhoeven b737eeb09e serial: Allow compile test of GPIO consumers if !GPIOLIB ... The GPIO subsystem provides dummy GPIO consumer functions if GPIOLIB is not enabled. Hence drivers that depend on GPIOLIB, but use GPIO consumer functionality only, can still be compiled if GPIOLIB is not enabled. Relax the dependency on GPIOLIB if COMPILE_TEST is enabled, where appropriate. Signed-off-by: Geert Uytterhoeven <geert@linux-m68k.org> Acked-by: Linus Walleij <linus.walleij@linaro.org> Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>		2015-08-04 22:07:21 -07:00
..
8250	serial: 8250: Auto CTS control by HW if AFE enabled	2015-08-04 22:07:21 -07:00
cpm_uart	tty: cpm_uart: replace CONFIG_8xx by CONFIG_CPM1	2015-03-26 23:00:36 +01:00
jsm	serial: jsm: some off by one bugs	2015-03-26 23:00:36 +01:00
21285.c
68328serial.c	tty: 68328serial.c: move assignment out of if () block	2015-05-10 19:04:16 +02:00
altera_jtaguart.c	drivers/tty/serial: altera: fix typos in #endif comments	2015-05-06 22:26:58 +02:00
altera_uart.c	drivers/tty/serial: altera: fix typos in #endif comments	2015-05-06 22:26:58 +02:00
amba-pl010.c
amba-pl011.c	serial: amba-pl011: Fix devm_ioremap_resource return value check	2015-07-23 15:05:53 -07:00
apbuart.c	tty: constify of_device_id array	2015-03-26 22:49:10 +01:00
apbuart.h
ar933x_uart.c
arc_uart.c
atmel_serial.c	tty/serial: at91: use 32bit writes into TX FIFO when DMA is enabled	2015-07-23 18:00:43 -07:00
bcm63xx_uart.c
bfin_sport_uart.c
bfin_sport_uart.h
bfin_uart.c	serial: bfin: ctsrts: enfore Kconfig naming convention	2015-05-06 22:26:59 +02:00
clps711x.c
crisv10.c	tty: crisv10.c: move assignment out of if () block	2015-05-10 19:04:17 +02:00
crisv10.h
digicolor-usart.c
dz.c
dz.h
earlycon-arm-semihost.c
earlycon.c	serial: earlycon: Add support for big-endian MMIO accesses	2015-06-01 06:55:12 +09:00
efm32-uart.c
etraxfs-uart.c	serial: etraxfs-uart: use mctrl_gpio helpers for handling modem signals	2015-08-04 22:07:20 -07:00
fsl_lpuart.c	Merge 4.0-rc7 into tty-next	2015-04-07 11:07:20 +02:00
icom.c	tty: icom.c: move assignment out of if () block	2015-05-10 19:04:17 +02:00
icom.h
ifx6x60.c	serial: ifx6x60: Remove superfluous casts when calling request_irq()	2015-05-06 22:27:01 +02:00
ifx6x60.h
imx.c	Serial: imx: add dev_pm_ops to support suspend to ram/disk	2015-08-03 15:51:19 -07:00
ioc3_serial.c	tty: ioc3_serial.c: move assignment out of if () block	2015-05-10 19:04:17 +02:00
ioc4_serial.c	tty: ioc4_serial.c: move assignment out of if () block	2015-05-10 19:04:17 +02:00
ip22zilog.c
ip22zilog.h
Kconfig	serial: Allow compile test of GPIO consumers if !GPIOLIB	2015-08-04 22:07:21 -07:00
kgdb_nmi.c	serial: kgdb_nmi: Use bool function return values of true/false not 1/0	2015-05-06 22:26:57 +02:00
kgdboc.c
lantiq.c	drivers/tty: make serial/lantic.c driver explicitly non-modular	2015-07-23 18:27:41 -07:00
lpc32xx_hs.c
m32r_sio.c
m32r_sio.h
m32r_sio_reg.h
Makefile	serial: stm32-usart: Add STM32 USART Driver	2015-06-10 17:34:26 -07:00
max310x.c
max3100.c
mcf.c	drivers/tty/serial/mcf.c: fix typo on SERIAL_MCF_CONSOLE	2015-05-06 22:26:59 +02:00
men_z135_uart.c
meson_uart.c	ARM: meson: serial: convert iounmap to devm_iounmap	2015-05-06 22:27:02 +02:00
mpc52xx_uart.c	serial: mpc52xx: let tx_empty callback return either 0 or TIOCSER_TEMT	2015-08-04 22:07:20 -07:00
mpsc.c	tty: mpsc.c: move assignment out of if () block	2015-05-10 19:04:17 +02:00
msm_serial.c
msm_serial.h	tty: serial: msm_serial: Remove dead code	2015-03-26 22:31:09 +01:00
mux.c
mxs-auart.c	serial: mxs: Constify platform_device_id	2015-05-10 19:08:16 +02:00
netx-serial.c
nwpserial.c
of_serial.c	serial: of_serial: check the return value of clk_prepare_enable()	2015-06-01 06:55:12 +09:00
omap-serial.c	serial: omap: Switch wake-up interrupt to generic wakeirq	2015-06-09 23:35:00 -07:00
pch_uart.c
pmac_zilog.c	tty: constify of_device_id array	2015-03-26 22:49:10 +01:00
pmac_zilog.h
pnx8xxx_uart.c
pxa.c	tty: constify of_device_id array	2015-03-26 22:49:10 +01:00
rp2.c
sa1100.c
samsung.c	serial: samsung: Remove redundant DEBUG_LL check	2015-07-23 18:27:41 -07:00
samsung.h
sb1250-duart.c
sc16is7xx.c	Merge 4.2-rc4 into tty-next	2015-07-27 11:12:39 -07:00
sccnxp.c
serial-tegra.c	serial: tegra: Fix memory leak on DMA setup failure	2015-05-24 12:53:44 -07:00
serial_core.c	serial: core: Fix crashes while echoing when closing	2015-07-23 18:08:28 -07:00
serial_ks8695.c	tty/serial: kill off set_irq_flags usage	2015-06-09 12:26:32 -07:00
serial_mctrl_gpio.c	TTY/Serial driver patches for 4.2-rc1	2015-06-26 15:53:22 -07:00
serial_mctrl_gpio.h
serial_txx9.c
sh-sci.c	TTY/Serial driver patches for 4.2-rc1	2015-06-26 15:53:22 -07:00
sh-sci.h	serial: sh-sci: Replace hardcoded overrun bit values	2015-05-10 19:06:39 +02:00
sirfsoc_uart.c	serial: sirf: let uart's receive start in right place	2015-07-23 15:32:04 -07:00
sirfsoc_uart.h	serial: sirf: let uart's receive start in right place	2015-07-23 15:32:04 -07:00
sn_console.c	drivers/tty: make serial/sn_console.c driver explicitly non-modular	2015-07-23 18:27:41 -07:00
sprd_serial.c	serial: sprd: check for NULL after calling devm_clk_get	2015-06-12 17:39:50 -07:00
st-asc.c	tty: constify of_device_id array	2015-03-26 22:49:10 +01:00
stm32-usart.c	serial: stm32-usart: Fix SysRq support	2015-07-23 17:37:53 -07:00
suncore.c	drivers/tty: make serial/suncore.c driver explicitly non-modular	2015-07-23 18:27:41 -07:00
sunhv.c	drivers/tty: make serial/sunhv.c driver explicitly non-modular	2015-07-23 18:27:41 -07:00
sunsab.c
sunsab.h
sunsu.c
sunzilog.c
sunzilog.h
tilegx.c
timbuart.c
timbuart.h
uartlite.c	serial: xilinx: Use platform_get_irq to get irq description structure	2015-04-28 14:26:21 +02:00
ucc_uart.c	serial/uuc_uart: Support higher bitrates than 115200 Bit/s	2015-07-23 18:05:00 -07:00
vr41xx_siu.c
vt8500_serial.c
xilinx_uartps.c	serial: xuartps: add __init to earlycon write method	2015-05-10 19:10:08 +02:00
zs.c
zs.h