mirror of
git://git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
synced 2025-08-05 16:54:27 +00:00
4296c70a5e
USB 3.0 hubs have a different remote wakeup policy than USB 2.0 hubs. USB 2.0 hubs, once they have remote wakeup enabled, will always send remote wakes when anything changes on a port. However, USB 3.0 hubs have a per-port remote wake up policy that is off by default. The Set Feature remote wake mask can be changed for any port, enabling remote wakeup for a connect, disconnect, or overcurrent event, much like EHCI and xHCI host controller "wake on" port status bits. The bits are cleared to zero on the initial hub power on, or after the hub has been reset. Without this patch, when a USB 3.0 hub gets suspended, it will not send a remote wakeup on device connect or disconnect. This would show up to the user as "dead ports" unless they ran lsusb -v (since newer versions of lsusb use the sysfs files, rather than sending control transfers). Change the hub driver's suspend method to enable remote wake up for disconnect, connect, and overcurrent for all ports on the hub. Modify the xHCI driver's roothub code to handle that request, and set the "wake on" bits in the port status registers accordingly. Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com> |
||
|---|---|---|
| .. | ||
| acpi | ||
| asm-generic | ||
| crypto | ||
| drm | ||
| keys | ||
| linux | ||
| math-emu | ||
| media | ||
| misc | ||
| mtd | ||
| net | ||
| pcmcia | ||
| rdma | ||
| rxrpc | ||
| scsi | ||
| sound | ||
| target | ||
| trace | ||
| video | ||
| xen | ||
| Kbuild | ||