Sven Eckelmann 6847f96733 ath10k: add board data download from target ... The QCA9887 stores its calibration data (board.bin) inside the EEPROM of the target. This has to be downloaded manually to allow the device to initialize correctly. Signed-off-by: Sven Eckelmann <sven.eckelmann@open-mesh.com> [kvalo@qca.qualcomm.com: handle -EOPNOTSUPP and s/fetch_board_data/fetch_cal_eeprom] Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>		2016-06-07 14:28:35 +03:00
..
admtek	cfg80211: remove enum ieee80211_band	2016-04-12 15:56:15 +02:00
ath	ath10k: add board data download from target	2016-06-07 14:28:35 +03:00
atmel	atmel: potential underflow in atmel_set_freq()	2016-05-11 22:02:20 +03:00
broadcom	brcmfmac: Add 4356 sdio support	2016-05-11 21:55:12 +03:00
cisco	airo: prevent potential underflow in airo_set_freq()	2016-05-11 22:01:38 +03:00
intel	* work for RX multiqueue continues (Sara);	2016-05-11 20:54:07 +03:00
intersil	prism54: isl_38xx: Replace 'struct timeval'	2016-04-26 12:09:17 +03:00
marvell	mwifiex: fixup error messages	2016-05-11 22:00:47 +03:00
mediatek	cfg80211: remove enum ieee80211_band	2016-04-12 15:56:15 +02:00
ralink	rt2800lib: enable MFP if hw crypt is disabled	2016-04-26 12:30:43 +03:00
realtek	rtlwifi: pci: use dev_kfree_skb_irq instead of kfree_skb in rtl_pci_reset_trx_ring	2016-05-11 21:59:04 +03:00
rsi	cfg80211: remove enum ieee80211_band	2016-04-12 15:56:15 +02:00
st	cfg80211: remove enum ieee80211_band	2016-04-12 15:56:15 +02:00
ti	wlcore/wl12xx: Fix fw logger over sdio	2016-05-11 21:26:15 +03:00
zydas	cfg80211: remove enum ieee80211_band	2016-04-12 15:56:15 +02:00
Kconfig
mac80211_hwsim.c	drivers/wireless: use nla_put_u64_64bit()	2016-04-26 12:00:48 -04:00
mac80211_hwsim.h	drivers/wireless: use nla_put_u64_64bit()	2016-04-26 12:00:48 -04:00
Makefile
ray_cs.c
ray_cs.h
rayctl.h
rndis_wlan.c	cfg80211: remove enum ieee80211_band	2016-04-12 15:56:15 +02:00
wl3501.h
wl3501_cs.c	cfg80211: remove enum ieee80211_band	2016-04-12 15:56:15 +02:00