The value used to identify chip variant is not an enumeration, but raw
value used to compare registers with. The 'enum' is not used in the
code at all, so simplify and make it a raw hex value define, so
intention will be explicit.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://patch.msgid.link/20250616-asoc-wcd93xx-enum-v1-1-a20a1b538509@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
Drop separate regulator get and enable in probe() path with
devm_regulator_bulk_get_enable(), which simplifies cleanup paths and
device remove().
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://patch.msgid.link/20250526-b4-asoc-wcd9395-vdd-px-v1-1-64d3cb60313b@linaro.org
Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@oss.qualcomm.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
'wcd_regmap_irq_chip' and 'jack' in 'struct wcd937x_priv' are not used
at all.
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Reviewed-by: Srinivas Kandagatla <srinivas.kandagatla@oss.qualcomm.com>
Link: https://patch.msgid.link/20250528-asoc-const-unused-v1-5-19a5d07b9d5c@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
Remove confusing and unused argument in swap_gnd_mic api, the second
argument active is not really used, and always set to true in the mbhc
drivers.
The callback itself is used to toggle the gnd_mic lines when a cross
connection is detected by mbhc circuits, so there is no need of this
argument.
Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
Link: https://patch.msgid.link/20250327100633.11530-4-srinivas.kandagatla@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
irq_domain_add_linear() is going away as being obsolete now. Switch to
the preferred irq_domain_create_linear(). That differs in the first
parameter: It takes more generic struct fwnode_handle instead of struct
device_node. Therefore, of_fwnode_handle() is added around the
parameter.
Note some of the users can likely use dev->fwnode directly instead of
indirect of_fwnode_handle(dev->of_node). But dev->fwnode is not
guaranteed to be set for all, so this has to be investigated on case to
case basis (by people who can actually test with the HW).
Signed-off-by: Jiri Slaby (SUSE) <jirislaby@kernel.org>
Cc: Liam Girdwood <lgirdwood@gmail.com>
Cc: Mark Brown <broonie@kernel.org>
Cc: Jaroslav Kysela <perex@perex.cz>
Cc: Takashi Iwai <tiwai@suse.com>
Cc: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Cc: linux-sound@vger.kernel.org
Link: https://patch.msgid.link/20250319092951.37667-36-jirislaby@kernel.org
Signed-off-by: Mark Brown <broonie@kernel.org>
When snd_soc_dapm_new_controls() or snd_soc_dapm_add_routes() fails,
wcd937x_soc_codec_probe() returns without releasing 'wcd937x->clsh_info',
which is allocated by wcd_clsh_ctrl_alloc. Add wcd_clsh_ctrl_free()
to prevent potential memory leak.
Fixes: 313e978df7 ("ASoC: codecs: wcd937x: add audio routing and Kconfig")
Cc: stable@vger.kernel.org
Signed-off-by: Haoxiang Li <haoxiang_li2024@163.com>
Link: https://patch.msgid.link/20250226085050.3584898-1-haoxiang_li2024@163.com
Signed-off-by: Mark Brown <broonie@kernel.org>
Add static channel mapping between master and slave ports in wcd937x-sdw
driver.
Currently, the channel mask for each soundwire port is hardcoded in the
wcd937x-sdw driver, and the same channel mask value is configured in the
soundwire master.
The Qualcomm boards like the QCM6490-IDP require different channel mask
settings for the soundwire master and slave ports.
Implemented logic to read TX/RX channel mappings from device tree
properties (qcom,tx-channel-mapping and qcom,rx-channel-mapping).
Modified the wcd937x_connect_port to handle master channel masks during
port enable/disable operations.
Added wcd937x_get_channel_map api to retrieve the current master
channel map for TX and RX paths.
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://patch.msgid.link/20250206112225.3270400-3-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
On a system with wcd937x, rxmacro and Qualcomm audio DSP, which is pretty
common set of devices on Qualcomm platforms, and due to the order of how
DAPM widgets are powered on (they are sorted), there is a small time window
when wcd937x chip is online and expects the flow of incoming data but
rxmacro is not yet online. When wcd937x is programmed to receive data
via AUX port then its AUX PDM watchdog is enabled in
wcd937x_codec_enable_aux_pa(). If due to some reasons the rxmacro and
soundwire machinery are delayed to start streaming data, then there is
a chance for this AUX PDM watchdog to reset the wcd937x codec. Such event
is not logged as a message and only wcd937x IRQ counter is increased
however there could be a lot of other reasons for that IRQ.
There is a similar opportunity for such delay during DAPM widgets power
down sequence.
If wcd937x codec reset happens on the start of the playback, then there
will be no sound and if such reset happens at the end of a playback then
it may generate additional clicks and pops noises.
On qrb4210 RB2 board without any debugging bits the wcd937x resets are
sometimes observed at the end of a playback though not always.
With some debugging messages or with some tracing enabled the AUX PDM
watchdog resets the wcd937x codec at the start of a playback and there
is no sound output at all.
In this patch:
- TIMEOUT_SEL bit in PDM_WD_CTL2 register is set to increase the watchdog
reset delay to 100ms which eliminates the AUX PDM watchdog IRQs on
qrb4210 RB2 board completely and decreases the number of unwanted clicks
noises;
- HOLD_OFF bit postpones triggering such watchdog IRQ till wcd937x codec
reset which usually happens at the end of a playback. This allows to
actually output some sound in case of debugging.
Cc: Adam Skladowski <a39.skl@gmail.com>
Cc: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Cc: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org>
Link: https://patch.msgid.link/20241022033132.787416-3-alexey.klimov@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
The wcd937x supports also AUX input but the control that sets correct
soundwire port for this is missing. This control is required for audio
playback, for instance, on qrb4210 RB2 board as well as on other
SoCs.
Reported-by: Adam Skladowski <a39.skl@gmail.com>
Reported-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Suggested-by: Adam Skladowski <a39.skl@gmail.com>
Suggested-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Cc: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org>
Link: https://patch.msgid.link/20241022033132.787416-2-alexey.klimov@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
After commit 0edb555a65 ("platform: Make platform_driver::remove()
return void") .remove() is (again) the right callback to implement for
platform drivers.
Convert all drivers below sound/soc to use .remove(), with the eventual
goal to drop struct platform_driver::remove_new(). As .remove() and
.remove_new() have the same prototypes, conversion is done by just
changing the structure member name in the driver initializer.
Signed-off-by: Uwe Kleine-König <u.kleine-koenig@baylibre.com>
Link: https://patch.msgid.link/20240909151230.909818-2-u.kleine-koenig@baylibre.com
Signed-off-by: Mark Brown <broonie@kernel.org>
The device never comes online from a reset/shutdown state, because the
driver de-asserts reset GPIO when requesting it but then, at the end of
probe() through wcd937x_reset(), leaves it asserted.
Cc: stable@vger.kernel.org
Fixes: 9be3ec196d ("ASoC: codecs: wcd937x: add wcd937x codec driver")
Signed-off-by: Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>
Link: https://patch.msgid.link/20240806114913.40022-1-krzysztof.kozlowski@linaro.org
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds audio routing for both playback and capture and
Makefile and Kconfigs changes for wcd937x.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-8-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds required dapm widgets for capture path.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-7-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds required dapm widgets for playback.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-6-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds basic controls found in WCD9370/WCD9375 codec.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-5-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
This patch adds basic SoundWire codec driver to support for
WCD9370/WCD9375 TX and RX devices.
The WCD9370/WCD9375 has Multi Button Headset Control hardware to
support Headset insertion, type detection, 8 headset buttons detection,
Over Current detection and Impedence measurements.
This patch adds support for this using wcd-mbhc apis.
Signed-off-by: Prasad Kumpatla <quic_pkumpatl@quicinc.com>
Co-developed-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Signed-off-by: Mohammad Rafi Shaik <quic_mohs@quicinc.com>
Link: https://lore.kernel.org/r/20240524035535.3119208-4-quic_mohs@quicinc.com
Signed-off-by: Mark Brown <broonie@kernel.org>
