On ASP versions v2.x we need to program the TX map vector register to
properly exercise end-to-end flow control, otherwise the TX engine can
either lock-up, or cause the hardware calculated checksum to be
wrong/corrupted when multiple back to back packets are being submitted
for transmission. This register defaults to 0, which means no flow
control being applied.
Fixes: e9f31435ee ("net: bcmasp: Add support for asp-v3.0")
Signed-off-by: Florian Fainelli <florian.fainelli@broadcom.com>
Link: https://patch.msgid.link/20250718212242.3447751-1-florian.fainelli@broadcom.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Make use of the return value from napi_complete_done(). This allows
users to use the gro_flush_timeout and napi_defer_hard_irqs sysfs
attributes for configuring software interrupt coalescing.
Signed-off-by: Florian Fainelli <florian.fainelli@broadcom.com>
Reviewed-by: Justin Chen <justin.chen@broadcom.com>
Reviewed-by: Joe Damato <joe@dama.to>
Link: https://patch.msgid.link/20250611212730.252342-2-florian.fainelli@broadcom.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
The asp-v3.0 is a major HW revision that reduced the number of
channels and filters. The goal was to save cost by reducing the
feature set.
Changes for asp-v3.0
- Number of network filters were reduced.
- Number of channels were reduced.
- EDPKT stats were removed.
- Fix a bug with csum offload.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>
Link: https://patch.msgid.link/20250422233645.1931036-8-justin.chen@broadcom.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
The SoC that supported asp-v2.0 never saw the light of day. asp-v2.0 has
quirks that makes the logic overly complicated. For example, asp-v2.0 is
the only revision that has a different wake up IRQ hook up. Remove asp-v2.0
support to make supporting future HW revisions cleaner.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>
Link: https://patch.msgid.link/20250422233645.1931036-4-justin.chen@broadcom.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Convert the Broadcom ASP2 driver to use phylib managed EEE support.
Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>
Tested-by: Florian Fainelli <florian.fainelli@broadcom.com>
Link: https://patch.msgid.link/E1tXk81-000r4x-TS@rmk-PC.armlinux.org.uk
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Fix the LPI timer handling in Broadcom ASP2 driver after the phylib
managed EEE patches were merged.
Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>
Tested-by: Florian Fainelli <florian.fainelli@broadcom.com>
Link: https://patch.msgid.link/E1tXk7r-000r4l-Li@rmk-PC.armlinux.org.uk
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Cross-merge networking fixes after downstream PR (net-6.12-rc4).
Conflicts:
107a034d5c ("net/mlx5: qos: Store rate groups in a qos domain")
1da9cfd6c4 ("net/mlx5: Unregister notifier on eswitch init failure")
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
The bcmasp_xmit() returns NETDEV_TX_OK without freeing skb
in case of mapping fails, add dev_kfree_skb() to fix it.
Fixes: 490cb41200 ("net: bcmasp: Add support for ASP2.0 Ethernet controller")
Signed-off-by: Wang Hai <wanghai38@huawei.com>
Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
Link: https://patch.msgid.link/20241014145901.48940-1-wanghai38@huawei.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
When bringing down the TX rings we flush the rings but forget to
reclaimed the flushed packets. This leads to a memory leak since we
do not free the dma mapped buffers. This also leads to tx control
block corruption when bringing down the interface for power
management.
Fixes: 490cb41200 ("net: bcmasp: Add support for ASP2.0 Ethernet controller")
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
Reviewed-by: Simon Horman <horms@kernel.org>
Link: https://lore.kernel.org/r/20240418180541.2271719-1-justin.chen@broadcom.com
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
phy_{suspend/resume} is redundant. It gets called from phy_{stop/start}.
Fixes: 490cb41200 ("net: bcmasp: Add support for ASP2.0 Ethernet controller")
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
The unimac requires the PHY RX clk during reset or it may be put
into a bad state. Bring up the unimac after link up to ensure the
PHY RX clk exists.
Fixes: 490cb41200 ("net: bcmasp: Add support for ASP2.0 Ethernet controller")
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
Hook up the phy interrupts for internal phys to reduce mdio traffic
and improve responsiveness of link changes.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
There is no advantage of freeing and re-allocating buffers through
suspend and resume. This waste cycles and makes suspend/resume time
longer. We also open ourselves to failed allocations in systems with
heavy memory fragmentation.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
ASP 2.2 improves power savings during low power modes.
A new register was added to toggle to a slower clock during low
power modes.
EEE was broken for ASP 2.0/2.1. A HW workaround was added for
ASP 2.2 that requires toggling a chicken bit.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Acked-by: Florian Fainelli <florian.fainelli@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Avoid the PHY library call unnecessarily into the suspend/resume
functions by setting phydev->mac_managed_pm to true. The ASP driver
essentially does exactly what mdio_bus_phy_resume() does.
Fixes: 490cb41200 ("net: bcmasp: Add support for ASP2.0 Ethernet controller")
Signed-off-by: Florian Fainelli <florian.fainelli@broadcom.com>
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
The buffer_pg variable needs to hold an order-5 allocation (32 x
PAGE_SIZE) which, under memory pressure may fail to be allocated. Deal
with that error condition properly to avoid doing a NULL pointer
de-reference in the subsequent call to dma_map_page().
In addition, the err_reclaim_tx error label in bcmasp_netif_init() needs
to ensure that the TX NAPI object is properly deleted, otherwise
unregister_netdev() will spin forever attempting to test and clear
the NAPI_STATE_HASHED bit.
Fixes: 490cb41200 ("net: bcmasp: Add support for ASP2.0 Ethernet controller")
Signed-off-by: Florian Fainelli <florian.fainelli@broadcom.com>
Reviewed-by: Justin Chen <justin.chen@broadcom.com>
Link: https://lore.kernel.org/r/20240213173339.3438713-1-florian.fainelli@broadcom.com
Signed-off-by: Paolo Abeni <pabeni@redhat.com>
bcmasp_get_eee() sets edata->eee_active and edata->eee_enabled from
its own copy, and then calls phy_ethtool_get_eee() which in turn will
call genphy_c45_ethtool_get_eee().
genphy_c45_ethtool_get_eee() will overwrite eee_enabled and eee_active
with its own interpretation from the PHYs settings and negotiation
result.
Therefore, setting these members in bcmasp_get_eee() is redundant, and
can be removed. This also makes intf->eee.eee_active unnecessary, so
remove this and use a local variable where appropriate.
Reviewed-by: Andrew Lunn <andrew@lunn.ch>
Reviewed-by: Florian Fainelli <florian.fainelli@broadcom.com>
Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
Link: https://lore.kernel.org/r/E1rWbNC-002cCt-W7@rmk-PC.armlinux.org.uk
Signed-off-by: Jakub Kicinski <kuba@kernel.org>
Add support for ethernet driver specific stats.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add support for wake on network filters. The max match is 256 bytes.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add support for Wake-On-Lan magic packet and magic packet with password.
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
Add support for the Broadcom ASP 2.0 Ethernet controller which is first
introduced with 72165. This controller features two distinct Ethernet
ports that can be independently operated.
Reviewed-by: Simon Horman <simon.horman@corigine.com>
Signed-off-by: Florian Fainelli <florian.fainelli@broadcom.com>
Signed-off-by: Justin Chen <justin.chen@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
