linux/drivers/firmware/microchip/Kconfig

# SPDX-License-Identifier: GPL-2.0-only

config POLARFIRE_SOC_AUTO_UPDATE
	tristate "Microchip PolarFire SoC AUTO UPDATE"
	depends on POLARFIRE_SOC_SYS_CTRL
	select FW_LOADER
	select FW_UPLOAD
	help
	  Support for reprogramming PolarFire SoC from within Linux, using the
	  Auto Upgrade feature of the system controller.

	  If built as a module, it will be called mpfs-auto-update.
firmware: microchip: add PolarFire SoC Auto Update support Add support for Auto Update reprogramming of the FPGA fabric on PolarFire SoC, using the fw_upload mechanism a la the intel-m10-bmc-sec-update driver. This driver only writes the image to the spi flash & performs validation on it, as the entire FPGA becomes unusable during the actual reprogramming of a bitstream. To initiate the reprogramming itself, a device reset is required. The SBI SRST extension's "cold reboot" can trigger such a device reset, provided corresponding support has been enabled in the HSS (Hart Software Services), the provider of SBI runtime services on PolarFire SoC. While this is a driver responsible for the reprogramming of an FPGA, there is no dynamic discovery of devices involved, as runtime reconfiguration is not possible due to the device reset requirements. Therefore FPGA manager subsystem is not used by this driver and the FPGA subsystem maintainers were unwilling to accept it there. Signed-off-by: Conor Dooley <conor.dooley@microchip.com> 2023-10-20 14:18:43 +01:00			`# SPDX-License-Identifier: GPL-2.0-only`

			`config POLARFIRE_SOC_AUTO_UPDATE`
			`tristate "Microchip PolarFire SoC AUTO UPDATE"`
			`depends on POLARFIRE_SOC_SYS_CTRL`
			`select FW_LOADER`
			`select FW_UPLOAD`
			`help`
			`Support for reprogramming PolarFire SoC from within Linux, using the`
			`Auto Upgrade feature of the system controller.`

			`If built as a module, it will be called mpfs-auto-update.`